Updated VNX100 Dumps Questions Are Available [2024] For Passing Versa Networks Exam
Free UPDATED Versa Networks VNX100 Certification Exam Dumps is Online
NEW QUESTION # 32
By default, when configuring DIA through workflows, which protocol runs between the tvi interfaces connecting an Internet VR with the LAN VRF?
- A. static routing
- B. OSPF
- C. BGP
- D. VRRP
Answer: C
Explanation:
By default, when configuring Direct Internet Access (DIA) through workflows, the protocol that runs between the tenant virtual router (VRF) and the transport WAN Virtual Router (VR), connected by the TVI interfaces, is EBGP (External Border Gateway Protocol). This protocol is used to control route distribution and is a fundamental part of the VOS Edge Device DIA Architecture. In such a configuration, the tenant VRF uses EBGP to advertise the default route, which is resolved using the logical tunnel created for DIA.
NEW QUESTION # 33
An administrator tries to run a speed test from a branch's Internet link to the Internet link of a remote site branch. However, the speed test fails.
In this scenario, what are two causes for the failure? (Choose two.)
- A. The speed test client is not enabled on the local site.
- B. The speed test server is not enabled on the remote site.
- C. The SLA path status between the branch sites over the Internet link is down.
- D. The speed test module has not been activated.
Answer: B,D
Explanation:
When a speed test fails, it could be due to the speed test module not being activated or the speed test server not being enabled at the remote site. If the speed test module has not been activated, the required functionality to conduct the test will not be operational. Similarly, if the remote site does not have the speed test server enabled, it won't respond to speed test requests. Issues with the SLA path status or client configuration might be relevant to the performance and reachability but are not cited as direct reasons for a speed test failure within the documentation provided.
NEW QUESTION # 34
Which two configuration options are set in a Device Template workflow? (Choose two.)
- A. Device Group
- B. serial number
- C. number of WAN/LAN ports
- D. Direct Internet Access
Answer: C,D
NEW QUESTION # 35
What are two roles of a Versa Controller? (Choose two.)
- A. to provide clock synchronization to the SD-WAN branches
- B. to provide connectivity to the rest of the head-end components
- C. to provide Internet breakout to the SD-WAN branches
- D. to onboard the SD-WAN branches
Answer: B,D
Explanation:
The roles of a Versa Controller include onboarding SD-WAN VOS branches into the network and maintaining a secure control channel with each node. The Versa Controller authenticates branch VOS instances, handles management activities between the remote and headend nodes, and distributes control plane information. It does not provide Internet breakout, which is a function typically performed by edge devices at the branches themselves, nor does it provide clock synchronization to the branches, which is generally a function of network protocols like NTP that operate independently of SD-WAN control.
NEW QUESTION # 36
Which three statements about Versa head-end component deployment are true? (Choose three.)
- A. The components can be deployed as virtual machines.
- B. The components can be deployed on a bare metal server.
- C. The components can be deployed as bare metal on non-x86 appliances.
- D. The components can be deployed as a mix of bare metal and virtual machines.
Answer: A,B,D
Explanation:
Versa SD-WAN headend components, which include the Versa Controller, Versa Director, and Versa Analytics, offer flexible deployment options. They can be deployed on bare metal servers, as virtual machines, or as a hybrid of both, depending on the scalability needs and the available infrastructure at the data center or cloud environment. This flexibility ensures that Versa SD-WAN can adapt to a variety of enterprise environments and deployment scenarios.
NEW QUESTION # 37
Which two statements about the Versa Secure SD-WAN solution are true? (Choose two.)
- A. Versa Director is used for end-user data traffic transport.
- B. Versa Controller provides historical usage reports.
- C. Versa CPEs are activated using Zero Touch Provisioning.
- D. All components support high availability.
Answer: C,D
Explanation:
Versa CPEs are indeed activated using Zero Touch Provisioning (ZTP), which automates the configuration process and reduces operational complexity. Furthermore, all components of the Versa SD-WAN solution support high availability configurations to ensure continuous operation and minimal disruption in the event of component failures. Versa Director and Versa Controllers can be deployed in redundant configurations, and Versa Analytics can be clustered for resilience and high availability.
NEW QUESTION # 38
When onboarding a CPE using ZTP, the device shows up in the unknown device list in the Versa Director Inventory.
In this scenario, what caused this problem?
- A. A non-Versa-branded appliance is used as the CPE.
- B. The CPE is installed as a virtual machine.
- C. The template workflow configuration does not have the correct serial number of the CPE defined.
- D. The device workflow configuration does not have the correct serial number of the CPE defined.
Answer: C
NEW QUESTION # 39
The Versa Stateful Firewall feature offers which two security capabilities? (Choose two.)
- A. Zone Protection
- B. Dynamic User Protection (DUP)
- C. Unified Threat Management (UTM)
- D. Distributed Denial of Service (DDoS) protection
Answer: A,C
Explanation:
The Versa Stateful Firewall feature encompasses a range of security capabilities, including Unified Threat Management (UTM), which may comprise antivirus, IPS, and web filtering services. It also provides Zone Protection, which enforces security policies based on the zones defined in the network to protect network segments. DDoS protection and DUP are also vital security functions, but they are not specified as capabilities within the Stateful Firewall feature set in the documents provided.
NEW QUESTION # 40
Review the exhibit.
Which set of conditions match the policy shown in the exhibit?
- A. Traffic flows that meet any one of the following three conditions:
Source Zone - Intf-LAN1 Zone
Source Zone - Intf-WLAN-Zone
Application - SharePoint - B. Traffic flows that meet all of the following two conditions:
Source Zone - Intf-LAN1 Zone
Source Zone - Intf-WLAN-Zone
In addition, the below condition must also match
Application - SharePoint - C. Traffic flows that meet any of the following two conditions:
Source Zone - Intf-LAN1 Zone
Source Zone - Intf-WLAN-Zone
In addition, the below condition must also match
Application - SharePoint - D. Traffic flows that meet any one of the following three conditions:
Source Zone - Intf-LAN1 Zone
Source Zone - Intf-WLAN-Zone
Application - SharePoint
Answer: C
Explanation:
The policy shown in the exhibit appears to match traffic flows based on multiple conditions involving the source zone and the application. Given the information in the screenshot:
* The policy is configured with multiple zones as source zones:Intf-LAN1-ZoneandIntf-WLAN-Zone.
* An application is specified:SHAREPOINT.
The policy is likely to be applied to traffic originating from either of the specified zones and specifically related to the SharePoint application. This implies that both conditions related to the source zones are not mutually exclusive but rather a union; the same goes for the application condition.
Given this interpretation, the correct set of conditions that match the policy shown would be:
B:Traffic flows that meet any of the following two conditions:
* Source Zone - Intf-LAN1 Zone
* Source Zone - Intf-WLAN-Zone
In addition, the below condition must also match:
* Application - SharePoint
This means that traffic will match the policy if it comes from either theIntf-LAN1-Zoneor the Intf-WLAN-Zoneandis SharePoint application traffic.
However, to be more precise in the context of Versa SD-WAN configurations, it's important to note that policies are usually applied when all conditions within a single rule are met. If the configuration in the screenshot intends to express that traffic is matched if it comes from either of the two zones and is for the SharePoint application, then the correct answer should reflect this logic. If the configuration system is set up to require all conditions in a rule to be met, then the answer could potentially be different. Since the user interface design can sometimes vary, it's important to understand the specific logic of the system in question.
NEW QUESTION # 41
Which two Versa solution components support REST APIs? (Choose two.)
- A. Versa Analytics
- B. Versa Director
- C. Versa CPE
- D. Versa Controller
Answer: A,B
Explanation:
Versa Analytics and Versa Director support REST APIs, which allow integration with third-party applications and systems. The REST APIs provided by these components enable automation and programmability for various network management and analytics functions. Versa Controller and Versa CPE are not referenced in the provided documents as supporting REST APIs directly, although they interact with Versa Director, which does.
NEW QUESTION # 42
A network operator wants to monitor a Versa CPE interface live data.
In this scenario, how would you accomplish this task?
- A. using Versa Analytics
- B. using Versa Director
- C. using the Versa CPE GUI
- D. using Versa Controller
Answer: B
Explanation:
To monitor a Versa CPE interface's live data, you would use the Versa Director. The Versa Director provides a comprehensive interface for real-time monitoring and management of SD-WAN infrastructure, including the visualization of traffic flows and performance metrics. Through Versa Director, network operators can gain insights into transmission data for all traffic or SD-WAN-specific traffic, updated every few seconds, and detailed information about interface statistics.
NEW QUESTION # 43
Which two statements about Versa Analytics are true? (Choose two.)
- A. Versa Analytics provides centralized logging information about the SD-WAN environment.
- B. Versa Analytics provides real-time traffic monitoring dashboards.
- C. Versa Analytics provides the ability to configure logging parameters on SD-WAN CPEs.
- D. Versa Analytics provides REST APIs for northbound integration with third-party tools.
Answer: B,D
Explanation:
Versa Analytics offers REST APIs that facilitate northbound integration with third-party tools, allowing for enhanced automation and the ability to pull data into external systems for additional processing or visualization. Moreover, it provides real-time traffic monitoringdashboards that deliver visibility into network performance, application usage, and security events, aiding in swift and informed decision-making. These dashboards are crucial for maintaining an overview of the network's current state and rapidly diagnosing issues.
Versa Analytics offers a suite of features aimed at enhancing visibility and control over SD-WAN networks.
The true statements about Versa Analytics are:
* Versa Analytics provides REST APIs for northbound integration with third-party tools (Answer B):
Versa Analytics is equipped with REST APIs that facilitate northbound integration, allowing organizations to seamlessly connect and integrate Versa's network data with third-party management, monitoring, and analytics tools. This integration capability is crucial for enterprises that utilize a diverse set of tools for network management and need to consolidate their network operations on a single platform.
* Versa Analytics provides real-time traffic monitoring dashboards (Answer D): One of the key features of Versa Analytics is its real-time traffic monitoring dashboards. These dashboards provide network administrators with live insights into network performance, traffic flows, and usage patterns, enabling them to make informed decisions quickly and effectively manage the network.
Option A (Versa Analytics provides the ability to configure logging parameters on SD-WAN CPEs) is incorrect because while Versa Analytics does involve extensive logging capabilities, the configuration of logging parameters typically occurs at the device or controller level, not within the analytics platform itself.
Option C (Versa Analytics provides centralized logging information about the SD-WAN environment) is somewhat misleading; while Versa Analytics does centralize data for analysis, it primarily focuses on providing analytical insights and data visualizations rather than merely centralizing logging information.
References:This explanation is based on the functionalities provided by Versa Analytics as part of the Versa SD-WAN solution, emphasizing its capabilities in network data integration and real-time monitoring.
NEW QUESTION # 44
Review the exhibit.
Which set of conditions match the policy shown in the exhibit?
- A. Traffic flows that meet any one of the following three conditions:
Source Zone - Intf-LAN1 Zone
Source Zone - Intf-WLAN-Zone
Application - SharePoint - B. Traffic flows that meet all of the following two conditions:
Source Zone - Intf-LAN1 Zone
Source Zone - Intf-WLAN-Zone
In addition, the below condition must also match
Application - SharePoint - C. Traffic flows that meet any of the following two conditions:
Source Zone - Intf-LAN1 Zone
Source Zone - Intf-WLAN-Zone
In addition, the below condition must also match
Application - SharePoint - D. Traffic flows that meet any one of the following three conditions:
Source Zone - Intf-LAN1 Zone
Source Zone - Intf-WLAN-Zone
Application - SharePoint
Answer: C
NEW QUESTION # 45
By default, when configuring DIA through workflows, which protocol runs between the tvi interfaces connecting an Internet VR with the LAN VRF?
- A. static routing
- B. OSPF
- C. BGP
- D. VRRP
Answer: C
NEW QUESTION # 46
Which statement about the function of an SD-WAN Forwarding Profile is true?
- A. It defines which of the WAN links should be selected to forward the outgoing traffic.
- B. It defines the link-performance parameters.
- C. It defines the criteria for matching traffic.
- D. It defines the criteria for custom applications and services.
Answer: A
NEW QUESTION # 47
What is the default load balancing algorithm set in an SD-WAN Forwarding Profile?
- A. Weighted Round Robin
- B. High Available Bandwidth
- C. Per Packet
- D. Per Flow
Answer: A
NEW QUESTION # 48
......
Versa Networks Exam 2024 VNX100 Dumps Updated Questions: https://validtorrent.pdf4test.com/VNX100-actual-dumps.html
